HP iLO 3 Scripting and Command Line Guide

SEC_DNS_SERVER specifies the IP address of the secondary DNS server. This parameter is only
relevant if the DHCP-assigned DNS server address feature is disabled. If an empty string is entered,
the current value is deleted.
TER_DNS_SERVER specifies the IP address of the tertiary DNS server. This parameter is only relevant
if the DHCP-assigned DNS server address feature is disabled. If an empty string is entered, the
current value is deleted.
PRIM_WINS_SERVER specifies the IP address of the primary WINS server. This parameter is only
relevant if the DHCP-assigned WINS server address feature is disabled. If an empty string is entered,
the current value is deleted.
SEC_WINS_SERVER specifies the IP address of the secondary WINS server. This parameter is only
relevant if the DHCP-assigned WINS server address feature is disabled. If an empty string is entered,
the current value is deleted.
STATIC_ROUTE_1, STATIC_ROUTE_2, and STATIC_ROUTE_3 are used to specify the destination
and gateway IP addresses of the static routes. The following two parameters are used within the
static route commands. If an empty string is entered, the current value is deleted.
• DEST specifies the destination IP addresses of the static route. This parameter is only relevant
if the DHCP-assigned static route feature is disabled. If an empty string is entered, the current
value is deleted.
• GATEWAY specifies the gateway IP addresses of the static route. This parameter is only
relevant if the DHCP-assigned static route feature is disabled. If an empty string is entered,
the current value is deleted.
DHCP_SNTP_SETTINGS is used to determine whether iLO is to get the SNTP time servers and
timezone from the DHCP server or whether the user enters that information manually.
SNTP_SERVER1 specifies the IP address of an IPv4 or IPv6 SNTP server or the FQDN of an SNTP
server. The FQDN must adhere to the DNS standard, for example time.nist.gov. The iLO firmware
contacts this server for the UTC time. If iLO is unable to contact this server, it attempts to contact
the Secondary Time Server. This parameter is only relevant if DHCP_SNTP_SETTINGS is set to No.
If an empty string is entered, the current value is deleted.
SNTP_SERVER2 specifies the IP address of an IPv4 or IPv6 SNTP server or the FQDN of an SNTP
server. The FQDN must adhere to the DNS standard, for example time.nist.gov. The iLO firmware
contacts this server for the UTC time. If iLO cannot contact the Primary Time Server, it contacts this
server. This parameter is only relevant if DHCP_SNTP_SETTINGS is set to No. If an empty string is
entered, the current value is deleted.
TIMEZONE specifies the current time zone from the Olson database. Using a web browser, in iLO
3 v1.40 or earlier, go to Administration→Network→SNTP Settings and select the correct time
zone from the Timezone list box. The text of the time zone name must be entered exactly as it
appears in the SNTP Settings time zone list box, (minus the GMT offset). America/Anchorage or
Europe/Zurich are two examples of a valid time zone.
For iLO 3 v1.50 and later, depending on which NIC is presently in use, navigate to Network+iLO
Dedicated Network Port and then select the SNTP tab, or navigate to Network+Shared Network
Port and then select the SNTP tab.
IPv6 MOD_NETWORK_SETTINGS parameters
If the following parameters are not specified, then the parameter value for the specified setting is
preserved. Zero values are not permitted in some fields. Consequently, an empty string deletes the
current value in some fields.
IPV6_ADDRESS is used to configure a static IPv6 address on iLO. When IPV6_ADDRESS entries
are included in a script, all previously configured IPv6 static addresses are deleted. Only the
82 RIBCL XML Scripting Language