HP iLO 3 Scripting and Command Line Guide

License commands
License commands enable you to display and modify the iLO license. Table 10 (page 47) shows
the License command properties. License commands are available at:
/map1/
Targets
None
Commands
Table 10 License Commands
DescriptionCommand
Changes the current directorycd
Displays license informationshow
Changes the current licenseset
For example
• set /map1 license=1234500000678910000000001
• show /map1 license
Directory commands
Directory commands enable you to view and modify directory settings. Table 12 (page 47) shows
the Directory command properties. Directory command settings are available at:
/map1/oemhp_dircfg1
Targets
The Directory Command Targets are shown in Table 11 (page 47).
Table 11 Directory Command Targets
DescriptionTarget
Contains a load verb used to load the binary keytab file from a given URL.
The keytab file may be up to 1024 bytes in length.
/map1/oemhp_dircfg1/
oemhp_keytab1
Properties
Table 12 Directory Command Properties
DescriptionAccessProperty
Enables or disables directory authentication. Valid settings are as
follows:
Read/Writeoemhp_dirauth
• extended_schema
Uses HP extended schema
• default_schema
Uses schema-free directories
• disabled
Directory-based authentication is disabled
Enables or disables local account authentication. This property can
be disabled only if directory authentication is enabled. Boolean
values accepted.
Read/Writeoemhp_localacct
Sets the directory server IP address or DNS name. The schema-free
directory configuration requires a DNS name.
Read/Writeoemhp_dirsrvaddr
Specific commands 47