HP iLO 3 Scripting and Command Line Guide

Properties
– WINSServerAddress
– RegisterThisConnection
– DHCPOptionToUse
◦ Verbs
– cd
– version
– exit
– show
• StaticIPSettings1
Properties
◦ oemhp_SRoute1Address
◦ oemhp_Mask1Address
◦ oemhp_Gateway1Address
◦ oemhp_SRoute2Address
◦ oemhp_Mask2Address
◦ oemhp_Gateway2Address
◦ oemhp_SRoute3Address
◦ oemhp_Mask3Address
◦ oemhp_Gateway3Address
◦ DHCPOptionToUse
Specify one or more properties on the command line. If multiple properties are on the same
command line, they must be separated by a space.
The iLO firmware resets after the network settings have been applied.
iLO 3 settings
The iLO 3 settings commands enable you to view or modify iLO 3 settings. Table 7 (page 42)
shows the iLO 3 properties. The iLO 3 settings are located at:
/map1/config1
Targets
No targets
Properties
Table 7 iLO Properties
DescriptionAccessProperty
Enables or disables iLO. Boolean values are accepted.Read/Writeoemhp_mapenable
Sets session timeout in minutes. Valid values are 15, 30, 60,
and 120.
Read/Writeoemhp_timeout
42 SMASH CLP Scripting Language