HP iLO 3 Scripting and Command Line Guide

delete Removes instances of the MAP in the name space.
load Moves a binary image from a URL to the MAP.
reset Causes a target to cycle from enabled to disabled, and back to enabled.
set Sets a property or set of properties to a specific value, and resets iLO to
implement the changes.
start Causes a target to change the state to a higher run level.
stop Causes a target to change the state to a lower run level.
version The command queries the version of the CLP implementation or other CLP
elements.
For example:
hpiLO-> version
status=0
status_tag=COMMAND COMPLETED
SM-CLP Version 1.0
oemhp_ping The command determines if an IP address is reachable from the current
iLO session.
For example:
oemhp_ping 192.168.1.1
Where 192.168.1.1 is the IP address you are testing.
Specific commands
The following sections cover iLO 3-specific commands available when using the command line,
including:
• “User commands” (page 37)
• “HP SSO settings” (page 37)
• “Network commands” (page 39)
• “iLO 3 settings” (page 42)
• “iLO 3 embedded health settings” (page 44)
• “SNMP settings” (page 46)
• “License commands” (page 47)
• “Directory commands” (page 47)
• “Virtual Media commands” (page 48)
• “Start and Reset commands” (page 51)
• “Firmware commands” (page 52)
• “Eventlog commands” (page 52)
• “Blade commands” (page 53)
• “Boot commands” (page 53)
• “LED commands” (page 55)
• “System properties and targets” (page 56)
• “Other commands” (page 59)
36 SMASH CLP Scripting Language