HP iLO 3 Scripting and Command Line Guide

<TER_DNS_SERVER value = "0.0.0.0"/>
<PRIM_WINS_SERVER value = "0.0.0.0"/>
<SEC_WINS_SERVER value = "0.0.0.0"/>
<STATIC_ROUTE_1 DEST = "0.0.0.0" GATEWAY = "0.0.0.0"/>
<STATIC_ROUTE_2 DEST = "0.0.0.0" GATEWAY = "0.0.0.0"/>
<STATIC_ROUTE_3 DEST = "0.0.0.0" GATEWAY = "0.0.0.0"/>
</MOD_NETWORK_SETTINGS>
</RIB_INFO>
<USER_INFO MODE="write">
<ADD_USER
USER_NAME = "admin"
USER_LOGIN = "admin"
PASSWORD = "%user_password%">
<ADMIN_PRIV value = "Y"/>
<REMOTE_CONS_PRIV value = "Y"/>
<RESET_SERVER_PRIV value = "Y"/>
<VIRTUAL_MEDIA_PRIV value = "Y"/>
<CONFIG_ILO_PRIV value = "Y"/>
</ADD_USER>
</USER_INFO>
</LOGIN>
</RIBCL>
NOTE: For security reasons, user passwords are not returned.
Obtaining a specific configuration
Obtain a specific configuration using the appropriate XML input file.
For example, the following is the contents of a typical XML input file:
get_global.xml
:
<!-- Sample file for Get Global command -->
<RIBCL VERSION="2.0">
<LOGIN USER_LOGIN="x" PASSWORD="x">
<RIB_INFO MODE="read">
<GET_GLOBAL_SETTINGS />
</RIB_INFO>
</LOGIN>
</RIBCL>
The XML commands are read from the input file get_global.xml and are processed by the
device:
hponcfg /f get_global.xml /l log.txt > output.txt
The requested information is returned in the log file, which, in this example, is named log.txt.
<GET_GLOBAL_SETTINGS>
<!-- A session timeout value of zero means that the timeout is set to infinite. -->
<SESSION_TIMEOUT VALUE="0"/>
<ILO_FUNCT_ENABLED VALUE="Y"/>
<F8_PROMPT_ENABLED VALUE="Y"/>
<F8_LOGIN_REQUIRED VALUE="N"/>
<HTTPS_PORT VALUE="443"/>
<HTTP_PORT VALUE="80"/>
<REMOTE_CONSOLE_PORT VALUE="17990"/>
<VIRTUAL_MEDIA_PORT VALUE="17988"/>
<SSH_PORT VALUE="22"/>
<SSH_STATUS VALUE="Y"/>
<SERIAL_CLI_STATUS VALUE="Enabled-Authentication Required"/>
<SERIAL_CLI_SPEED VALUE="9600"/>
<MIN_PASSWORD VALUE="8"/>
<AUTHENTICATION_FAILURE_LOGGING VALUE="Enabled-every 3rd failure"/>
<RBSU_POST_IP VALUE="Y"/>
26 HPONCFG online configuration utility