HP iLO 3 Scripting and Command Line Guide

<!-- iLO 3 - Version 1.20 or later only -->
<DIR_GRPACCT2_SID value= "S-2-0"/>
<DIR_GRPACCT3_NAME value = "test3"/>
<DIR_GRPACCT3_PRIV value = "1,3,4"/>
<!-- Firmware support information for next tag: -->
<!-- iLO 4 - All versions. -->
<!-- iLO 3 - Version 1.20 or later only -->
<DIR_GRPACCT3_SID value= "S-3-0"/>
<DIR_GRPACCT4_NAME value = "test4"/>
<DIR_GRPACCT4_PRIV value = "3,6"/>
<!-- Firmware support information for next tag: -->
<!-- iLO 4 - All versions. -->
<!-- iLO 3 - Version 1.20 or later only -->
<DIR_GRPACCT4_SID value= "S-4-0"/>
<DIR_GRPACCT5_NAME value = "test5"/>
<DIR_GRPACCT5_PRIV value = "2,3"/>
<!-- Firmware support information for next tag: -->
<!-- iLO 4 - All versions. -->
<!-- iLO 3 - Version 1.20 or later only -->
<DIR_GRPACCT5_SID value= "S-5-0"/>
<DIR_GRPACCT6_NAME value = "test6"/>
<DIR_GRPACCT6_PRIV value = "1,3,4,6"/>
<!-- Firmware support information for next tag: -->
<!-- iLO 4 - All versions. -->
<!-- iLO 3 - Version 1.20 or later only -->
<DIR_GRPACCT6_SID value= "S-6-0"/>
<!-- alternative method for ilo3/4 only -->
<!-- <DIR_GRPACCT INDEX="1"> -->
<!-- <NAME VALUE="string"/> -->
<!-- <SID VALUE="S-1-0"/> -->
<!-- <LOGIN_PRIV VALUE="Y"/> -->
<!-- </DIR_GRPACCT> -->
</MOD_DIR_CONFIG>
</DIR_INFO>
</LOGIN>
</RIBCL>
MOD_DIR_CONFIG parameters
All of the following parameters are optional. If a parameter is not specified, then the parameter
value for the specified setting is preserved.
DIR_AUTHENTICATION_ENABLED enables or disables directory authentication. The possible
values are Yes and No.
DIR_ENABLE_GRP_ACCT causes iLO to use schema-less directory integration. The possible values
are Yes and No.
When using schema-free directory integration, iLO supports variable privileges associated with
different directory groups. These groups are contained in the directory, and the corresponding
member iLO privileges are stored in iLO.
DIR_KERBEROS_ENABLED enables or disables Kerberos authentication. The possible values are
Yes and No.
DIR_KERBEROS_REALM specifies the Kerberos realm for which the domain controller is configured.
By convention, the Kerberos realm name for a given domain is the domain name converted to
uppercase.
DIR_KERBEROS_KDC_ADDRESS specifies the location of the domain controller. The domain
controller location is specified as an IP address or DNS name.
112 RIBCL XML Scripting Language