iLO 2 Scripting and Command Line Guide

ManualsBrandsHP ManualsComputer AccessoriesHP Integrated Lights-Out 2 (iLO 2) Firmware for ProLiant G6 Servers

Capturing and restoring a configuration

Use HPONCFG to capture basic configuration information in an XML readable file format. Use

this file to set or restore the iLO configuration. This feature is available with HPONCFG version

1.2 and later. HPONCFG writes the configuration information in the HP RIBCL format.

• To capture a configuration, you must specify the name and location of the output file on the

command line.

For example:

hponcfg /w config.xml

HPONCFG displays a message when it successfully writes the configuration information to

the output file as requested. The following is an example of the contents of the output file:

<DIR_INFO MODE="write">

<MOD_DIR_CONFIG>

<DIR_AUTHENTICATION_ENABLED VALUE = "N"/>

<DIR_LOCAL_USER_ACCT VALUE = "Y"/>

<DIR_SERVER_ADDRESS VALUE = ""/>

<DIR_SERVER_PORT VALUE = "636"/>

<DIR_OBJECT_DN VALUE = ""/>

<DIR_OBJECT_PASSWORD VALUE = ""/>

<DIR_USER_CONTEXT_1 VALUE = ""/>

<DIR_USER_CONTEXT_2 VALUE = ""/>

<DIR_USER_CONTEXT_3 VALUE = ""/>

</MOD_DIR_CONFIG>

</DIR_INFO>

<RIB_INFO MODE="write">

<MOD_NETWORK_SETTINGS>

<SPEED_AUTOSELECT VALUE = "Y"/>

<NIC_SPEED VALUE = "100"/>

<FULL_DUPLEX VALUE = "Y"/>

<DHCP_ENABLE VALUE = "Y"/>

<DHCP_GATEWAY VALUE = "Y"/>

<DHCP_DNS_SERVER VALUE = "Y"/>

<DHCP_STATIC_ROUTE VALUE = "Y"/>

<DHCP_WINS_SERVER VALUE = "Y"/>

<REG_WINS_SERVER VALUE = "N"/>

<IP_ADDRESS VALUE = "16.100.241.229"/>

<SUBNET_MASK VALUE = "255.255.252.0"/>

<GATEWAY_IP_ADDRESS VALUE = "16.100.240.1"/>

<DNS_NAME VALUE = "ILOD234KJ44D002"/>

<DOMAIN_NAME VALUE = "americas.cpqcorp.net"/>

<PRIM_DNS_SERVER value = "16.81.3.242"/>

<SEC_DNS_SERVER value = "0.0.0.0"/>

<TER_DNS_SERVER value = "0.0.0.0"/>

<PRIM_WINS_SERVER value = "16.81.3.247"/>

<SEC_WINS_SERVER value = "0.0.0.0"/>

<STATIC_ROUTE_1 DEST = "0.0.0.0" GATEWAY = "0.0.0.0"/>

<STATIC_ROUTE_2 DEST = "0.0.0.0" GATEWAY = "0.0.0.0"/>

<STATIC_ROUTE_3 DEST = "0.0.0.0" GATEWAY = "0.0.0.0"/>

</MOD_NETWORK_SETTINGS>

<USER_INFO MODE="write">

<ADD_USER

USER_NAME = "Username1"

USER_LOGIN = "User1"

PASSWORD = "%user_password%">

<ADMIN_PRIV value = "N"/>

<REMOTE_CONS_PRIV value = "Y"/>

<RESET_SERVER_PRIV value = "N"/>

72 HPONCFG online configuration utility