iLO 2 Scripting and Command Line Guide

ManualsBrandsHP ManualsComputer AccessoriesHP Integrated Lights-Out 2 (iLO 2) Firmware for ProLiant G6 Servers

<NIC_SPEED VALUE = "100"/>

<FULL_DUPLEX VALUE = "Y"/>

<DHCP_ENABLE VALUE = "Y"/>

<DHCP_GATEWAY VALUE = "Y"/>

<DHCP_DNS_SERVER VALUE = "Y"/>

<DHCP_STATIC_ROUTE VALUE = "Y"/>

<DHCP_WINS_SERVER VALUE = "Y"/>

<REG_WINS_SERVER VALUE = "N"/>

<IP_ADDRESS VALUE = "16.100.241.229"/>

<SUBNET_MASK VALUE = "255.255.252.0"/>

<GATEWAY_IP_ADDRESS VALUE = "16.100.240.1"/>

<DNS_NAME VALUE = "ILOD234KJ44D002"/>

<DOMAIN_NAME VALUE = "americas.cpqcorp.net"/>

<PRIM_DNS_SERVER value = "16.81.3.242"/>

<SEC_DNS_SERVER value = "0.0.0.0"/>

<TER_DNS_SERVER value = "0.0.0.0"/>

<PRIM_WINS_SERVER value = "16.81.3.247"/>

<SEC_WINS_SERVER value = "0.0.0.0"/>

<STATIC_ROUTE_1 DEST = "0.0.0.0" GATEWAY = "0.0.0.0"/>

<STATIC_ROUTE_2 DEST = "0.0.0.0" GATEWAY = "0.0.0.0"/>

<STATIC_ROUTE_3 DEST = "0.0.0.0" GATEWAY = "0.0.0.0"/>

</MOD_NETWORK_SETTINGS>

<USER_INFO MODE="write">

<ADD_USER

USER_NAME = "Username1"

USER_LOGIN = "User1"

PASSWORD = "%user_password%">

<ADMIN_PRIV value = "N"/>

<REMOTE_CONS_PRIV value = "Y"/>

<RESET_SERVER_PRIV value = "N"/>

<VIRTUAL_MEDIA_PRIV value = "N"/>

<CONFIG_ILO_PRIV value = "N"/>

</ADD_USER>

</USER_INFO>

</LOGIN>

</RIBCL>

NOTE: For security reasons, user passwords are not returned.

Obtaining a specific configuration

Obtain a specific configuration using the appropriate XML input file.

For example, the following is the contents of a typical XML input file:

get_global.xml

<RIB_INFO MODE="read">

<GET_GLOBAL_SETTINGS />

</RIB_INFO>

</LOGIN>

</RIBCL>

The XML commands are read from the input file get_global.xml and are processed by the

device:

hponcfg /f get_global.xml /l log.txt > output.txt

The requested information is returned in the log file, which, in this example, is named log.txt.

HPONCFG utility 69