iLO 2 Scripting and Command Line Guide

• “License commands” (page 25)
• “Directory commands” (page 26)
• “Virtual media commands” (page 26)
• “Start and reset commands” (page 29)
• “Firmware update” (page 30)
• “Eventlog commands” (page 31)
• “Blade commands” (page 32)
• “Boot commands” (page 33)
• “LED commands” (page 34)
• “System properties and targets” (page 34)
• “Other commands” (page 37)
User commands
User commands enable you to view and modify user settings. User settings are located at
/map1/accounts1.
Targets
All local users are valid targets. For example, if there are three local users with the login names
Administrator, admin, and test, then valid targets would be:
• Administrator
• admin
• test
Properties
DescriptionAccessProperty
Corresponds to the iLO 2 login name.read/write
username
Corresponds to the password for the current user.read/write
password
Displays the name of the user. If a name is not specified, the parameter
uses the same value as the login name (username). This value corresponds
to the iLO 2 user name property.
read/write
name
Specifies the privilege level. The valid values are as follows:read/write
group
• admin
• config
• oemhp_power
• oemhp_rc
• oemhp_vm
If a group is not specified, no privileges are assigned to the user.
Examples
The current path is /map1/accounts1.
• create username=lname1 password=password
Specific commands 17