HP Integrated Lights-Out 2 User Guide

Click Cancel to close the automated setup wizard. Click Next to set up your blade server. The setup
wizard will guide you through:
1. iLO 2 configuration
2. Server RAID verification
3. Virtual media connection
4. Software installation
The iLO 2 firmware configuration screen
This screen enables you to change the following settings:
• Administrator password. HP recommends changing the default password.
• Network configuration settings. The following are the default settings:
Enable DHCP – Yes◦
◦ Enable Static IP Bay Configuration – No
• If connected to the blade in enclosure slot 1, you can enable Static IP Bay configuration to
preconfigure the static address for other iLO 2 processors in the enclosure.
In the default configuration, the iLO 2 being updated gets its IP address through DHCP. Other iLO
2 processors in the enclosure must be configured separately. If these settings are not changed,
clicking Next displays the next page in the setup wizard. If either of these settings are changed,
iLO 2 reboots to invoke the updated settings.
The following configuration combinations are also available (the default setting is in parentheses):
• Enable DHCP (Yes) and Enable Static IP Bay Configuration (Yes)
This configuration causes the iLO 2 being configured to get its IP address through DHCP.
Clicking Next displays the Static IP Bay Configuration page, enabling you to specify the IP
ProLiant BL p-Class configuration 71