HP Integrated Lights-Out 2 Management Processor Scripting and Command Line Resource Guide

<SHARED_NETWORK_PORT VALUE="N"/>

</MOD_NETWORK_SETTINGS>

</RIB_INFO>

</LOGIN>

</RIBCL>

MOD_NETWORK_SETTINGS parameters

If the following parameters are not specified, then the parameter value for the specified setting is

preserved. Zero values are not permitted in some fields. Consequently, an empty string deletes the

current value in some fields.

ENABLE_NIC – Enables the NIC to reflect the state of iLO 2. The values are Yes or No. It is case

insensitive.

SHARED_NETWORK_PORT – Sets the Shared Network Port value. The values are Yes or No. For

iLO, the Shared Network Port feature is only available on servers with hardware, NIC firmware,

and iLO firmware that supports this feature. For iLO 2, the Shared Network Port is supported on

all firmware versions, and the feature is available if the hardware is supported.

Minimum iLO firmware versionProLiant server

1.64DL320G3

1.60DL360 G4

1.64DL360 G4

1.60DL380 G4

1.64DL385 G1

1.64DL580 G3

1.60ML370 G4

1.64ML570 G3

When using the iLO 2 Shared Network Port, flashing the iLO 2 firmware through the XML interface

takes approximately 7 minutes to complete. Flashing the firmware using Shared Network Port with

iLO 2 does not take any longer to complete than using the dedicated iLO 2 management port.

VLAN_ENABLED VALUE – Enables iLO 2 Shared Network Port VLAN ID tagging. The possible

values are yes or No.

VLAN_ID VALUE – Sets the VLAN ID value. Values must be between 1 and 4094.

REG_DDNS_SERVER VALUE – Instructs iLO 2 to register the management port with a DDNS server.

The possible values are Yes or No.

SPEED_AUTOSELECT – A Boolean parameter to enable or disable the iLO 2 transceiver to

auto-detect the speed and duplex of the network. This parameter is optional, and the Boolean string

must be set to Yes if this behavior is desired. If this parameter is used, the Boolean string value

must never be left blank. The possible values are Yes or No. It is case insensitive.

FULL_DUPLEX – Used to decide if the iLO 2 is to support full-duplex or half-duplex mode. It is only

applicable if SPEED_AUTOSELECT was set to No. The possible values are Yes or No. It is case

insensitive.

NIC_SPEED – Used to set the transceiver speed if SPEED_AUTOSELECT was set to No. The possible

values are 10 or 100. Any other values results in a syntax error.

88 Using RIBCL