HP Integrated Lights-Out 2 Management Processor Scripting and Command Line Resource Guide

<DHCP_DNS_SERVER value="Yes"/>
<DHCP_WINS_SERVER value="Yes"/>
<DHCP_STATIC_ROUTE value="Yes"/>
<REG_WINS_SERVER value="Yes"/>
<PRIM_DNS_SERVER value="0.0.0.0"/>
<SEC_DNS_SERVER value="0.0.0.0"/>
<TER_DNS_SERVER value="0.0.0.0"/>
<PRIM_WINS_SERVER value="0.0.0.0"/>
<SEC_WINS_SERVER value="0.0.0.0"/>
<STATIC_ROUTE_1 DEST="0.0.0.0" GATEWAY="0.0.0.0"/>
<STATIC_ROUTE_2 DEST="0.0.0.0" GATEWAY="0.0.0.0"/>
<STATIC_ROUTE_3 DEST="0.0.0.0" GATEWAY="0.0.0.0"/>
<!-- This tag can be used on an iLO blade server to force iLO -->
<!-- to attempt to get an IP address from the signal backplane -->
<!-- in a server enclosure. The IP address must be set prior -->
<!-- with Mod_Enc_Bay_IP_Settings.xml -->
<!-- <ENCLOSURE_IP_ENABLE VALUE="Yes"/> -->
</MOD_NETWORK_SETTINGS>
</RIB_INFO>
</LOGIN>
Modify VLAN example:
<RIBCL version="2.21">
<LOGIN USER_LOGIN="adminname" PASSWORD="password">
<RIB_INFO MODE="WRITE" >
<MOD_NETWORK_SETTINGS>
<SHARED_NETWORK_PORT VALUE="Yes"/>
<VLAN_ENABLED VALUE="Yes"/>
<VLAN_ID VALUE="1"/>
</MOD_NETWORK_SETTINGS>
</RIB_INFO>
</LOGIN>
</RIBCL>
RBSU POST IP example:
<RIBCL version="2.21">
<LOGIN USER_LOGIN="adminname" PASSWORD="password">
<RIB_INFO MODE="write" >
<MOD_GLOBAL_SETTINGS>
<RBSU_POST_IP VALUE="Y"/>
</MOD_GLOBAL_SETTINGS>
</RIB_INFO>
</LOGIN>
</RIBCL>
Shared network port example:
<RIBCL version="2.21">
<LOGIN USER_LOGIN="adminname" PASSWORD="password">
<RIB_INFO MODE="WRITE" >
<MOD_NETWORK_SETTINGS>
RIB_INFO 87