HP Integrated Lights-Out 2 Management Processor Scripting and Command Line Resource Guide

iLO 2 is reset after network settings have been applied.
iLO 2 settings
The iLO 2 settings commands enable you to view or modify iLO 2 settings. iLO 2 settings are
located at /map1/config1.
Targets
No targets
Properties
• oemhp_rawvspport=3002
• oemhp_console_capture_port=17990
• oemhp_console_capture_enable=yes
• oemhp_interactive_console_replay_enable=yes
• oemhp_capture_auto_export_enable=no
• oemhp_capture_auto_export_location=http://192.168.1.1/folder/
capture%t.ilo
• oemhp_capture_auto_export_username=0
• oemhp_capture_auto_export_password=0
• oemhp_console_capture_boot_buffer_enable=no
• oemhp_console_capture_fault_buffer_enable=no
• emhp_shared_console_enable=yes
• oemhp_shared_console_port=0
• oemhp_key_up_key_down_enable=yes
DescriptionAccessProperty
Enables or disables the iLO 2. Boolean values are accepted.Read/Write
oemhp_mapenable
Sets session timeout in minutes. Valid values are 15, 30, 60,
and 120.
Read/Write
oemhp_timeout
Enables or disables Terminal Services Passthrough. Boolean
values are accepted.
Read/Write
oemhp_passthrough
Enables or disables RBSU prompt during POST. Boolean
values are accepted.
Read/Write
oemhp_rbsuenable
Enables or disables login requirement for accessing RBSU.
Boolean values are accepted.
Read/Write
oemhp_rbsulogin
Enables or disables iLO 2 IP address display during POST.
Boolean values are accepted.
Read/Write
oemhp_rbsushowip
Enables or disables Telnet.Read/Write
oemhp_telnetenable
Sets the HTTP port value.Read/Write
oemhp_httpport
Sets the SSL port value.Read/Write
oemhp_sslport
Sets remote console port value.Read/Write
oemhp_rcport
Sets virtual media port value.Read/Write
oemhp_vmport
Sets Terminal Services port value.Read/Write
oemhp_tsport
Specific commands 21