HP Integrated Lights-Out 2 Management Processor Scripting and Command Line Resource Guide

If you do not specify a property, then all properties are shown. In the case of the /map1/
firmware1 context, there are two properties available: version and date. If you execute
show /map1/firmware1 date, only the date is shown.
• create – Creates a new instance of the MAP in the name space.
• delete – Removes instances of the MAP in the name space.
• load – Moves a binary image from a URL to the MAP.
• reset – Causes a target to cycle from enabled to disabled, and then back to enabled.
• set – Sets a property or set of properties to a specific value, and resets iLO 2 to implement
the changes.
• start – Causes a target to change its state to a higher run level.
• stop – Causes a target to change its state to a lower run level.
• version – Queries the version of the CLP implementation or other CLP elements. For example:
hpiLO-> version
status=0
status_tag=COMMAND COMPLETED
SM-CLP Version 1.0
• oemhp_ping – Determines if an IP address is reachable from the current iLO 2. For example:
oemhp_ping 192.168.1.1
where 192.168.1.1 is the IP address you are testing.
Specific commands
The following sections cover iLO 2 specific commands available when using the command line,
including:
• “User commands” (page 17)
• “HP SIM SSO settings” (page 17)
• “Network commands” (page 18)
• “iLO 2 settings” (page 21)
• “iLO 2 embedded health settings” (page 22)
• “SNMP settings” (page 24)
• “License commands” (page 25)
• “Directory commands” (page 25)
• “Virtual media commands” (page 26)
• “Start and reset commands” (page 29)
• “Firmware update” (page 30)
• “Eventlog commands” (page 30)
• “Blade commands” (page 31)
• “Boot commands” (page 32)
• “LED commands” (page 33)
• “System properties and targets” (page 33)
• “Other commands” (page 36)
16 Command line