HP Integrated Lights-Out 2 Management Processor Scripting and Command Line Resource Guide

DescriptionDefault valueParameter
Terminal Services client and Terminal Services server
running on the host. The following settings are valid:
• Automatic – When remote console is started, the
Terminal Services client is launched.
• Enabled – The pass-through feature is enabled and
can connect the Terminal Services client directly to
the iLO 2 without logging-into the iLO 2.
• Disabled – The pass-through feature is off.
This setting enables you to specify the Terminal Services
Port that the iLO 2 uses for encrypted communications
3389Terminal Services Port
with Terminal Services Pass-through software on the
server. If the Terminal Services port is configured to
anything other than the default, you must manually
change the port number.
This setting enables you to specify the port for virtual
media support in iLO 2 communications.
17988Virtual Media Port
This setting enables you to specify the Shared Remote
Console Port. The Shared Remote Console Port is
9300Shared Remote Console Port
opened on the client to allow additional users to
connect to remote console in a peer-to-peer fashion.
This port is only open when Shared Remote Console is
in use.
This setting enables you to specify the Console Replay
Port. The Console Replay Port is opened on the client
17990Console Replay Port
to enable the transfer of internal capture buffers to the
client for replay. This port is only open when a capture
buffer is being transferred to the client.
This setting specifies the Raw Serial Data port address.
The Raw Serial Data port is only open while the
3002Raw Serial Data Port
WiLODbg.exe utility is being used to debug the host
server remotely.
Settings (parameters) found on the Encryption page of the iLO 2 user interface.
DescriptionDefault valueParameter
Displays the current cipher for this web browser session.
Upon logging into the iLO 2 using the web browser, the
Current cipher
browser and the iLO 2 negotiate the cipher setting to be
used for the session. This web page displays the negotiated
cipher.
This setting allows you to enable or disable AES/3DES
encryption.
Enforce AES/3DES Encryption
• Disabled – AES/3DES encryption is not used.
• Enabled – Cipher strength must be at least AES or 3DES
to connect to iLO 2.
Network parameters
DefinitionDefault valueParameter
This parameter enables the NIC to reflect the state of the iLO 2. The
default setting for the NIC is yes, which is enabled. If DHCP is
YesNIC
Network parameters 159