HP Insight Remote Support and Insight Online Setup Guide for HP ProLiant Gen8 Servers and HP BladeSystem c-Class Enclosures

The Data Collection Information section displays the following information:
• Last Data Collection Transmission—The date and time when data was last sent to HP
• Last Data Collection Status—The status of the last data transmission
• Next Scheduled Data Collection (Direct Connect only)—The next date and time when data will
be sent to HP.
Use the following procedure to send data immediately:
1. Log in to the OA web interface (https://<OA hostname or IP address>).
2. Navigate to the Enclosure Settings→Remote Support→Data Collections page, as shown in
Figure 25 (page 38).
Figure 25 OA Data Collections page
3. Click Send Data Collection.
When the transmission is finished, the following message appears:
Manual data collection completed successfully.
The Last Data Collection Transmission date and time are updated. The date and time are based
on the configured OA time zone.
4. (Optional) Check the Insight RS Console to verify that the data collection information is
displayed.
For instructions, see “Viewing data collection information in the Insight RS Console (Central
Connect configurations only)” (page 40).
5. (Optional) Check Insight Online to verify that the data collection timestamp is accurate.
For instructions, see “Viewing data collection information in Insight Online” (page 39).
Sending Active Health System reporting information (HP ProLiant Gen8
servers only)
Depending on whether you use the Direct or Central Connect configuration, iLO or the Insight RS
Hosting Device sends information about the health, configuration, and runtime telemetry of the
server to HP. This information is used for troubleshooting issues and closed-loop quality analysis.
38 Working with service events and collections