HP Insight Remote Support and Insight Online Setup Guide for HP ProLiant Gen8 Servers and HP BladeSystem c-Class Enclosures

Figure 24 iLO Data Collections page
3. Click Send Data Collection.
You must have the Configure iLO Settings privilege to perform this task.
The following message appears:
Are you sure you want to send a Data Collection?
4. Click OK.
The following messages appear:
Data Collection Transmission initiated.
Data Collection Transmission in progress.
When the transmission is complete, the Last Data Collection Transmission and the Last Data
Collection Transmission Status are updated. The date and time are based on the configured
iLO time zone.
5. (Optional) Check the Insight RS Console to verify that the data collection information is
displayed.
For instructions, see “Viewing data collection information in the Insight RS Console (Central
Connect configurations only)” (page 40).
6. (Optional) Check Insight Online to verify that the data collection timestamp is accurate.
For instructions, see “Viewing data collection information in Insight Online” (page 39).
Sending data collection information with OA
Depending on whether you use the Direct or Central Connect configuration, OA or the Insight RS
Hosting Device sends information about the server configuration to HP for analysis and proactive
services that are consistent with your warranty and existing service agreements.
• For Direct Connect configurations, this data is transmitted every 30 days. You cannot edit or
delete the data collection schedule.
• For Central Connect configurations, the data transmission frequency is configured in the Insight
RS Console on the Insight RS Hosting Device. For information about configuring the data
collection schedule, see the HP Insight RS online help.
Sending data collection information 37