HP Insight Remote Support 7.0.9 Release Notes

HP Insight Remote Support 7.0.9 Release Notes
30
HP StoreEasy Storage (formerly Commercial NAS)
WMI needs to be configured and enabled on the File Serving Nodes to send hardware events to the Hosting Device. For
setup instructions, see the HP Insight Remote Support Monitored Devices Configuration Guide available at
www.hp.com/go/insightremotesupport/docs.
The following HP StoreEasy Storage (formerly Network Attached Storage NAS) are supported:
 HP ProLiant Storage Server family (excluding 1xx series)
 HP All-in-One 600 and 1200 Storage Systems
 HP NAS Series including
 HP X1000 Network Storage Systems
 HP X3000 Network Storage Systems
 HP X1800 G2 Network Storage Systems
 HP X3800 G2 Network Storage Systems
 HP X5520 G2 Network Storage Systems
 HP StoreEasy 1xx0 Storage
 HP StoreEasy 3xx0 Gateway Storage
 HP StoreEasy 5000 Storage
 HP 3PAR File Controller Storage
 HP 3PAR File Controller Storage V2
Note
The following HP Network Attached Storage (NAS) are not supported with the HP Insight Remote Support software:
– HP StorageWorks Storage Server (NAS) 1000s Network Attached Storage 1000s
– HP StorageWorks Storage Server (NAS) 1200s Small Business Class Family Network Attached Storage 1200s
– HP StorageWorks Storage Server (NAS) 1500s Network Attached Storage 1500s
– HP StorageWorks Storage Server (NAS) s1000 Network Attached Storage S1000 Model 320/640
– HP StorageWorks Storage Server (NAS) 8000 Network Attached Storage 8000
– HP Surestore Storage Server (NAS) VA Solutions Network Attached, HP-UX based storage solution Unix
– Compaq Storage Server (NAS) N2400 Network Attached Storage 2400
– HP StorageWorks AIO400 Storage System
HP Storage Blades
The following HP Storage Blades are supported with this release:
 HP All-in-One SB600c Storage System
 HP All-in-One SB920c Tape Blade
 HP D2000sb Storage Blades
HP StoreFabric (formerly SAN Fibre Channel Switches)
SNMP v1 or v2 needs to be configured and enabled for HP Storage Switches to be able to send events to the Hosting Device.
 B-series Fibre Channel (FC) Switches (Brocade) including
 HP DC SAN Backbone Director Switches (DCX)
 HP 1606 Extension SAN Switches
 HP 8/80 SAN Switches
 HP Brocade 8Gb SAN Switch for BladeSystem c-Class
Test trap support for HP B-series Fibre Channel switches requires the installation of Fabric Operating system v6.3.0b
firmware or higher. See the HP Fabric OS 6.3.0b Customer Advisory or details.
 C-series Fibre Channel Switches (Cisco MDS Fibre Channel Switches, including support for Cisco NX-OS version 5.x.)
 H-series Fibre Channel Switches including
 HP SN6000 Fibre Channel Switches
 HP SN6000B Fibre Channel Switches
 HP StoreFabric SN6500B 16Gb 96/96 Switches