HP Insight Remote Support 7.0.9 Release Notes

HP Insight Remote Support 7.0.9 Release Notes
24
Table 10. Required software components for HP-UX 11i v2
Version required
Notes
PHSS_36870
System Fault
Management
(SFM)
B.07.01.01.yy System Fault Management (May,
2009) or later
See the System Fault Management Release
Notes for more details and additional SFM
prerequisites at www.hp.com/go/hpux-
diagnostics-sfm-docs.
Table 11. Required software components for HP-UX 11i v3
Version required
Notes
HP-UX Operating
Environment
11iv3
 EVM-EventMgr B.11.31 or later
 Baseboard Management Controller (BMC)
firmware version 05.21 or later
 SysMgmtBase B.00.02.03 or later
The Baseboard Management Controller firmware
is only required for rx3600 and rx6600 servers to
provide the correct Power & Cooling information
to System Fault Manager.
OpenSSL Secure
Network
Communications
Protocol
A.00.09.07e.013 or later
Online
Diagnostics:
Diagnostic and
Support Tools for
HP-UX, including
STM version
A.49.10 or later and
EMS version
A.04.20 or later
B.11.31.01.yy or later (SysFaultMgmt version
dependency see notes)
Important: You are advised to check the WBEM
Services Release Notes including the WBEM
Provider Compatibility Table for that product
version, if you need to install or update this
service.
System
Management Web
(recommended for
event monitoring,
required for
configuration
collection)
A.2.2.4 HP-UX Web Based System Management
User Interfaces (December, 2007) or later
System Management Web is optional, but it
allows you to take full advantage of SFM's EVWEB
GUI component which allows viewing of events
handled by SFM on the host.
If only SysMgmtHomepage version 2.2.6.2 is
present on the server, then the following patch
must also be applied:
For HP-UX 11i v3 (11.31) OE apply patch
PHSS_36871
System Fault
Management
(SFM)
1
C.07.10.08.yy HPUX System Fault Management
or later
See the System Fault Management Release Notes
for more details and additional SFM prerequisites
at www.hp.com/go/hpux-diagnostics-sfm-docs.
1
HP recommends installing SFM thorugh the WBEMMgmtBundle available at:
https://h20392.www2.hp.com/portal/swdepot/displayProductInfo.do?productNumber=WBEMMgmtBundle
HP-UX machine check abort automatic analysis capabilities for HP-UX 11i v3
HP-UX machine check abort automatic analysis is available for all HP Integrity servers.
Note
The following servers require the installation of a specific System Fault Management (SFM) version to enable this capability:
 HP Integrity BL8x0c i2 running System Fault Management April 2011 version or higher
 HP Integrity rx2800 i2 running System Fault Management April 2011 version or higher
This SFM version is delivered as a part of Diagnostics Products Collection depot (April 2011 release or higher) available from
Software Depot at: h20392.www2.hp.com/portal/swdepot/displayInstallInfo.do?productNumber=DiagProdCollection.