HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide
Configuring the Management Module of the IBM BladeCenter® Chassis 130
Install IBM Device Drivers and Service Processor Firmware 133
Add Protocol Credentials and Start Discovery 134
Discover the Device in the Insight RS Console 134
Configure Warranty and Contract Information 134
Chapter 16: Configuring Dell PowerEdge Servers 136
Fulfill Configuration Requirements 136
Install and Configure Communication Software on Servers 136
Configure the Windows SNMP Service 136
Install and Configure SNMP 138
Installing Dell OpenManage Server Administrator 138
Configuring SNMP Traps in Dell OpenManage Server Administrator 139
Add Protocol Credentials and Start Discovery 140
Discover the Device in the Insight RS Console 140
Configure Warranty and Contract Information 140
Chapter 17: Configuring BladeSystem c-Class Enclosures 141
Configuring BladeSystem c-Class Enclosures Through the OA 141
Fulfill Configuration Requirements 142
Register the OAand Verify Discovery 142
Register Remote Support Through the Onboard Administrator 142
Verify Communication Between Monitored Device and Insight RS 143
Sending a Test Event 143
Maintenance and Troubleshooting 144
Disable Monitoring of a BladeSystem c-Class Enclosure 144
Configuring BladeSystem c-Class Enclosures Using SNMP 145
Fulfill Configuration Requirements 145
Install and Configure Communication Software on Enclosures 145
Configure SNMP on the BladeSystem c-Class Enclosure 145
Add Protocol Credentials and Start Discovery 146
Create an SNMP Protocol Credential in Insight RS 146
Discover the Device in the Insight RS Console 147
Maintenance and Troubleshooting 147
HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 9 of 267
Contents