HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

Chapter 11: Configuring Integrity HP-UX Servers
Before attempting to configure Insight Remote Support for your HP-UX monitored device, read the
following information.
Note: Insight Remote Support version 7.0.9 only supports HP-UX on Integrity servers.
Fulfill Configuration Requirements
To configure your Integrity HP-UX servers to be monitored by Insight RS, complete the following steps:
Task Completed?
Make sure Insight RS supports your Integrity HP-UX server by checking the HP Insight
Remote Support Release Notes.
Install System Fault Management prerequisites on the Integrity HP-UX server:
l OS patches
l OpenSSL Secure Network Communications Protocol
l Online Diagnostics
l WBEM Services Core Product
l System Management Web
Install and configure System Fault Management on the Integrity HP-UX server.
Configure WBEM users on the HP-UX server.
Set firewall to allow communication on specific ports.
Add the WBEM protocol to the Insight RS Console.
Discover the HP-UX server in the Insight RS Console.
Send a test event to verify connectivity to the Hosting Device.
Table 11.1 Integrity HP-UX Server Configuration Steps
Install and Configure Communication Software on
Servers
To configure your monitored devices, complete the following sections:
Install System Fault Management
System Fault Management (SFM) is an Insight Remote Support communications requirement on all
supported versions of HP-UX. SFM has many patch prerequisites, and those are detailed in the section
"Meeting HP-UX Operating System, Software, and Patch Requirements". If your system(s) already meet
Page 89 of 267HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide