HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

SNMP Agents are required for VMware ESX monitored devices. Once you have installed the SNMP
Agents on your monitored devices, use SMH to edit the snmpd.conf file to add the Hosting Device IP
address and the SNMP community string. This enables SNMP communication from the monitored device
to the Hosting Device. You will need to do this for each VMware ESX monitored device.
Note: You can also edit the snmpd.conf file in a text editor if you are not using SMH.
The Hosting Device must be able to communicate with the monitored device. To configure the monitored
device to send traps to the Hosting Device, complete the following steps:
1. In a web browser, access System Management Homepage (SMH) on the monitored device:
https://[ipaddress]:2381.
2. Log on using the monitored device root user name and password.
3. In the top menu bar, click Settings.
4. Click the SNMP Configuration link.
5.
In the SNMP Configuration File add a trapsink command that includes the IP address for your
Hosting Device, for example trapsink 1.2.3.4 public, and click Change.
The trapsink command is required for events to be sent to Insight Remote Support for analysis. If
the trapsink command is not configured, Insight Remote Support will not receive traps.
A rocommunity directive allows SNMP GET and GETNEXT access. It is required for discovery and by the
analysis rules. The format is: rocommunity <community_string>, for example rocommunity
public. The community string used must be the same read community string configured in the
Insight RS Console SNMP protocol assigned to the ProLiant ESX server. The rocommunity is used
during analysis rules trap processing to retrieve additional information not supplied with traps.
The rwcommunity directive allows SNMP GET, GETNEXT, and SET access. It is not required for use by
Insight Remote Support, but may be needed by other applications.
Note: If you do not use the public community string in the trapsink entry, then you must
add a new SNMP protocol for this monitored device in the Insight RS Console that uses the
same community string.
HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 63 of 267
Chapter 5: Configuring ProLiant VMware ESX Servers