HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

Test Communication from the ProLiant Gen8 Server to
Insight RS
To test communication of your monitored devices, complete the following steps:
Verify Service Event Monitoring
After registering the ProLiant Gen8 server with Insight Remote Support, send a test event to confirm the
connection.
Note: Sending SNMP test traps from the iLO 4 web interface Administration → Management
page is not supported in Insight Remote Support. To send a test event, do so from the Remote
Support → Service Events page as shown below.
To send a test event, complete the following steps:
1.
Log on to the iLO 4 web interface (https://<iLO hostname or IP address>).
2. In the navigation menu, click Remote Support → Service Events. The Service Events screen
appears.
3. Click Send Test Event. The following message appears:
Are you sure you want to send a test event?
4. Click OK to confirm that you want to send the test event. The following messages appear:
Test Service Event Transmission has been initiated
Service Event transmission in progress.
When the transmission is complete, the test event is listed in the Service Event Log and in the Insight
RS Console. If the test is successful, the Submit Status column displays the text No Error.
HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 39 of 267
Chapter 2: Configuring ProLiant Gen8 Servers