HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

#
snmp-agent
snmp-agent community read public
snmp-agent sys-info version v1
snmp-agent target-host trap address udp-domain <hosting_device_ip> params securitynam
e public v1
#
If any of the settings are incorrect, use the undo command to remove the setting, for example, undo
snmp-agent community read public. Then return to "Setup SNMP Traps" on page 244 and reconfigure
the setting that was incorrect.
HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 246 of 267
Chapter 33: Configuring ComWare-based Networking Switches