HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

ready.

Type the exit command to disconnect.

Configure SNMP Communication

To verify that SNMP communication is working properly, complete the following steps:

1. Type the show version command to determine which software version your ProVision-based switch

is running:

# sho ver

2. Type the config command to enable the global configuration mode:

# config

The output should show a version number similar to x.14.60, where x will be a letter such as K.

4. Use the snmp-server command to type the Hosting Device's IP address. Depending on the version

of the firmware on the ProVision-based switch, use one of the following versions of the command:

Firmware version Command

14.60 and lower

# snmp-server host <IP address> public not-info

14.61 and higher

# snmp-server host <IP address> community public trap-

level not-info

5. Verify that the settings you just typed were saved:

# sho run

6. Type the write memory command to save the configuration changes:

# write mem

HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 237 of 267

Chapter 32: Configuring ProVision-based Networking Switches