HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide
Chapter 31: Configuring StoreFabric H-Series
Switches
Fulfill Configuration Requirements
To configure your StoreFabric H-Series Switches to be monitored by Insight RS, complete the following
steps:
Task Complete?
Make sure Insight RS supports your H-Series switch by checking the HP Insight
Remote Support Release Notes.
Configure SNMPv1 on the H-Series switch.
Add the SNMP protocol to the Insight RS Console.
Discover the H-Series switch in the Insight RS Console.
Verify the status of the H-Series switch in the Insight RS Console.
Table 31.1 StoreFabric H-Series Switch Configuration Steps
Install and Configure Communication Software on
SANSwitches
To configure your monitored devices, complete the following sections:
Configure SNMP
Log on to the switch with Telnet and issue the following CLI commands to configure the HP SN6000,
8/20q and 2/8q FC switches to send SNMP traps to the Hosting Device.
1. Open the Admin session:
admin start
2. Configure the SNMP trap destinations:
set setup snmp
3.
After configuration, type y to save and active the SNMP setup.
4. Close the Admin session:
admin end
Add Protocol Credentials and Start Discovery
To discover your monitored devices, complete the following steps:
Page 232 of 267HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide