HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

Discovery Monitoring Basic

Collections

SAN

Collections

Notes

HP Servers

ProLiant Gen8 RIBCL RIBCL RIBCL HP ProLiant Gen8 servers can be monitored using the

embedded management capabilities in the iLO 4 or using a

diagnostic agent installed on the operating system.

Note, if you want to monitor attached devices you need to

install the HP Service Pack for ProLiant as detailed in the

ProLiant server section that corresponds to the operating

system below.

RIBCL credentials are required for all HP ProLiant Gen8

servers regardless if the embedded capabilities or the

diagnostic agent are used.

See "Configuring ProLiant Gen8 Servers" on page 36.

Windows on

ProLiant

SNMPv1,

SNMPv2,

SNMPv3

or WMI

SNMPv1,

SNMPv2,

SNMPv3

or WMI

SNMPv1,

SNMPv2,

SNMPv3

or WMI

Must install the HP Service Pack for ProLiant and all

providers that ship with it.

You can choose to use SNMP or WMI, however to gather

SAN Collections for a ProLiant Windows server, you must

use WMI and Service Pack for ProLiant version 2.8 or later.

See "Configuring ProLiant Windows Servers" on page 45.

For configuring using WMI, see "Configuring ProLiant

Windows Servers Using WMI" on page 45.

For configuring using SNMP, see "Configuring ProLiant

Windows Servers Using SNMP" on page 49.

WMI

Table 1.1 Required Monitored Device Communication Protocols and Components for Insight RS Services

HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 23 of 267

Chapter 1: Understanding Monitored Devices Prerequisites