HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

1. Telnet or SSH to the B-Series switch.
2. Show the available traps you can send as tests:
snmptraps --show
3. Send a blanket test trap for all tests:
snmptraps --send
4. Or send a specific test trap:
snmptraps --send --trap_name <trapname>
For example:
snmptraps --send -trap_name cp-status-change-trap -ip_address <hosting_device_ip>
where <hosting_device_ip> is the IP address of the Hosting Device. If the switch reports that the
test trap cannot be sent, make sure snmpmibcaps is configured to send HA traps. If it is configured
correctly, this command should create a test event visible in the Insight RS Console and also submit
an incident to HP.
Note: Not all traps result in an incident being delivered to the Insight RS Console. Not all traps
are sent and not all are received. Some get received as ‘unregistered event’ if you have that
option selected as a receive option in Events. The events that show up as ‘unregistered’ are not
compiled in the SIM Mibs. FA-MIB’s generate a valid hardware event.
See the B-Series Switch documentation for more details.
HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 228 of 267
Chapter 29: Configuring StoreFabric B-Series Switches