HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide
Configure SNMPon Your StoreOnce Backup (D2D) Systems
You must add the Hosting Device as a trap destination on your D2D Backup Systems for service events
to reach Insight RS.
Configure SNMP for StoreOnce Gen2 Backup (D2D) Systems
To configure SNMP for StoreOnce Backup (D2D) Systems, complete the following steps:
1.
Log on to the StoreOnce Backup System as "administrator" using https://<StoreOnce_Backup_
IP>.
2. Click the Configuration tab.
3. On the Device Configuration pane, click the SNMP tab.
4. Click Edit, then enable the SNMP agent by selecting the SNMP Enabled check box.
5. Use the Hosting Device IP address to add a destination.
HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 209 of 267
Chapter 27: Configuring StoreOnce Backup (D2D) Systems