HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

Chapter 27: Configuring StoreOnce Backup
(D2D) Systems
Fulfill Configuration Requirements
To configure your StoreOnce Backup (D2D) Systems to be monitored by Insight RS, complete the
following steps:
Task Complete?
Make sure Insight RS supports your StoreOnce Backup (D2D) System by checking the
HP Insight Remote Support Release Notes.
Verify Firmware version on the StoreOnce Backup (D2D) System.
Configure SNMP on the StoreOnce Backup (D2D) System.
Add the SNMP protocol to the Insight RS Console.
Discover the StoreOnce Backup (D2D) System in the Insight RS Console.
Table 27.1 StoreOnce Backup (D2D) System Configuration Steps
Install and Configure Communication Software on
Backup Systems
To configure your monitored devices, complete the following sections:
Verify the Firmware Version
Insight RS only supports StoreOnce Backup systems that use firmware version 2.1.03 or above. Check
the firmware version in the StoreOnce Backup user interface as shown below. If your firmware version is
older than version 2.1.03, update your firmware to a supported version.
Page 208 of 267HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide