HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

Chapter 26: Configuring Virtual Library Systems
Fulfill Configuration Requirements
To configure your Virtual Library Systems to be monitored by Insight RS, complete the following steps:
Task Complete?
Make sure Insight RS supports your Virtual Library System by checking the HP Insight
Remote Support Release Notes.
Configure SNMP on the Virtual Library System.
Discover the Virtual Library System in the Insight RS Console.
Send a test event to verify connectivity between your Virtual Library System and Insight
RS.
Table 26.1 Virtual Library System Configuration Steps
Install and Configure Communication Software on
Virtual Library Systems
To configure your monitored devices, complete the following sections:
Configure SNMP on the Virtual Library System
To support your Virtual Library System (VLS) Tape Libraries, you need to configure SNMP in Command
View for Virtual Library Systems (VLS).
To configure SNMP on your VLS Tape Libraries, complete the following steps:
1. Log on to the Command View VLS web interface of each VLS node.
2. Click the Notifications tab.
3. Click the Edit SNMP settings task. Note that this task may be called SNMP Setup, depending on
your version of Command View VLS.
4. In the Hostname field, type the Hosting Device IP address or FQDN.
Page 206 of 267HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide