HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

# service snmpd restart
l HP SNMP Agents:
# service hp-snmp-agents start
To ensure that hp-snmp-agents restarts when the system is rebooted, type the following command:
# chkconfig hp-snmp-agents on
Add Protocol Credentials and Start Discovery
To discover your monitored devices, complete the following steps:
Create an SNMP Protocol Credential in Insight RS
If your device's SNMP community string is set to public and your community access mode is read
only, Insight RS automatically associates an SNMPv1 protocol with your device. If you use a different
community string or use a nonstandard port, you must create an SNMPv1 protocol credential in the Insight
RS Console.
To configure SNMPv1 in the Insight RS Console, complete the following steps:
1. In a web browser, log on to the Insight RS Console.
2. In the Main Menu, select Discovery and click the Credentials tab.
3. From the Select and Configure Protocol drop-down list, select Simple Network Management
Protocol Version 1.
4. Click New. The New Credential dialog box appears.
5. Enter the Community String you have configured on your device.
6. Click Add.
Insight RS creates the protocol credential and it appears in the credentials table.
Discover Nodes in Insight Remote Support or HP SIM
Insight Remote Support and HP SIM can be configured to discover system-specific network segments, a
targeted host, or IP address ranges.
To discover the device from the Insight RS Console, complete the following steps:
1. In a web browser, log on to the Insight RS Console.
2. In the main menu, select Discovery and click the Sources tab.
3. Expand the IP Addresses section and type the IP address for your device.
4. Click Start Discovery.
HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 203 of 267
Chapter 25: Configuring StoreAll Network Storage Systems