HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide
Chapter 22: Configuring MSA2xxx G1 Modular
Smart Arrays
Important: Configuration collections are not supported, except when the MSA2xxx G1 is part of
a SAN collection.
Fulfill Configuration Requirements
To configure your MSA2xxx G1 Modular Smart Arrays to be monitored by Insight RS, complete the
following steps:
Task Complete?
Make sure Insight RS supports your Modular Smart Array by checking the HP Insight
Remote Support Release Notes.
Configure SNMP on the MSA.
Add the SNMP protocol to the Insight RS Console.
Discover the Modular Smart Array server in the Insight RS Console.
Table 22.1 P2000 and Modular Smart Array Configuration Steps
Install and Configure Communication Software on
Arrays
To configure your monitored devices, complete the following sections:
Configure SNMP on Your MSA2xxx G1 Modular Smart
Arrays
Each MSA monitored device has factory-installed SNMP on the device.
To access the Storage Management Utility for the MSA 2012 or 2112 and configure SNMP for Insight
Remote Support, complete the following steps:
1. Log on to the HP MSA Storage Management Utility.
Note: For basic information about setting up this tool and managing your credentials,
consult the MSAStorage Management Utility documentation at:
http://www.hp.com/support/manuals.
2. Select Manage.
Page 189 of 267HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide