HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

1. In a web browser, log on to the Insight RS Console.
2. In the Main Menu, select Discovery and click the Credentials tab.
3. From the Select and Configure Protocol drop-down list, select Simple Network Management
Protocol Version 1.
4. Click New. The New Credential dialog box appears.
5. Enter the Community String you have configured on your device.
6. Click Add.
Insight RS creates the protocol credential and it appears in the credentials table.
Create a WBEM Protocol Credential in Insight RS
To configure WBEM in the Insight RS Console, complete the following steps:
1. In a web browser, log on to the Insight RS Console.
2. In the main menu, select Discovery and click the Credentials tab.
3. From the Select and Configure Protocol drop-down list, select Web-Based Enterprise
Management (WBEM).
4. Click New. The New Credential dialog box appears.
5. Enter the Username and Password used to access the Storage Management Utility interface on the
P2000.
6. Click Add.
Insight RS creates the protocol credential and it appears in the credentials table.
Discover the Device in the Insight RS Console
To discover the device from the Insight RS Console, complete the following steps:
1. In a web browser, log on to the Insight RS Console.
2. In the main menu, select Discovery and click the Sources tab.
3. Expand the IP Addresses section and add the IP address for your device:
a. Click New.
b. Select the Single Address, Address Range, or Address List option.
c. Type the IP address(es) of the P2000 G3 devices to be discovered.
Important: In a dual-controller system, you must discover both controller A and
controller B if both exist. If you do not discover both controllers, events that originate
HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 182 of 267
Chapter 20: Configuring P2000 G3 Modular Smart Arrays