HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

7. Using the VI Client, power on the VSA.
8. Find the VSA in the CMC and apply the upgrade.
Verify Management Group Version
l When upgrading from version LeftHand OS 7.x to release 9.5 or higher, the management group version
will not move to the new release version until all storage nodes in the management group (and in the
remote management group if a Remote Copy relationship exists) are upgraded to release LeftHand OS
9.5 or higher.
l When upgrading from LeftHand OS version 7.x to release 9.5 or higher, the upgrade process validates
the hardware identity of all of the storage nodes in the management group. If this validation fails for any
reason, the management group version will not be upgraded to 9.5 or higher. For example, if a
management group has a mix of platforms, some of which are unsupported by a software release; then
only the supported platforms get upgraded successfully, the management group version will not be
upgraded if the unsupported platforms remain in that management group.
To verify the management group version, complete the following steps:
1. In the CMC navigation window, select the management group, and then select the Registration tab.
The management group version number is at the top of the Registration Information section, as
shown in figure "Verifying the Management Group Version Number" below.
Figure 19.3 Verifying the Management Group Version Number
Check for Patches
After you have upgraded LeftHand OS, use CMC to check for applicable patches required for your storage
node. CMC 9.0 and higher shows available patches and can be used to download them from HP to the
CMC system.
Configuring SNMP on the P4000 Storage System
Use the following procedure to verify your SNMP settings. If you did not modify the LeftHand OS SNMP
settings when you installed/upgraded LeftHand OS then you should not need to make any updates during
the following procedure.
With LeftHand OS, you can configure different severity Alert levels to send from the Management Group.
Under Insight Remote Support, configure each Management Group to send v1 SNMP traps of Critical
and Warning levels in Standard message text length.
HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 169 of 267
Chapter 19: Configuring StoreVirtual P4000 Storage Systems