HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

Fulfill Configuration Requirements 242
Install and Configure Communication Software on Switches 242
Configure Telnet or SSH 242
Configuring Telnet 242
Configuring SSH Version 2 243
Verifying Telnet/SSH Communication 244
Setup SNMP Traps 244
Saving the Current Configuration 244
Add Protocol Credentials and Start Discovery 244
Discover the Device in the Insight RS Console 245
Verify Warranty and Contract Information 245
Verify Communication Between Monitored Device and Insight RS 245
Verifying SNMP Communication 245
Chapter 34: Configuring Uninterruptable Power Supplies 247
Configuring UPS Management Modules 247
Fulfill Configuration Requirements 247
Install and Configure Communication Software on Management Modules 247
Configure SNMP 247
Add Protocol Credentials and Start Discovery 248
Create an SNMP Protocol Credential in Insight RS 248
Discover the Device in the Insight RS Console 249
Verify Communication Between Monitored Device and Insight RS 249
Send a Test Trap 249
Configuring UPS Network Modules 249
Fulfill Configuration Requirements 250
Install and Configure Communication Software on Network Modules 250
Configure SNMP 250
Add Protocol Credentials and Start Discovery 252
Create an SNMP Protocol Credential in Insight RS 252
Discover the Device in the Insight RS Console 252
Verify Communication Between Monitored Device and Insight RS 253
Send a Test Trap 253
HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 16 of 267
Contents