HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

11. From the SNMPv1 agent drop-down list, select Enabled.
12. Configure an SNMPv1 Community:
a. In the Community Name field, type a SNMP community name.
b. From the Access Type drop-down list, select Get.
c. In the Host Name or IP Address field, type the Hosting Device host name or IP address.
13. Click Save.
14. Restart the BladeCenter Management Module:
a. In the MM Control section of the left menu, select Restart MM.
b. Click Restart.
Install IBM Device Drivers and Service Processor Firmware
To use an attached device, its device drivers must be installed. Make sure that the appropriate IBM
server’s service processors are installed.
Note:
l To determine which service processors are installed on an IBM server, refer to the
Implementing Systems Management Solutions using IBM Director document at:
HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 133 of 267
Chapter 15: Configuring IBM Servers