HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

Configure the Windows SNMP Service
1. On the monitored device, open the SNMP Service Properties window and select the Traps tab.
2. In the Community name field, type the SNMP community name and click Add to list.
Important: The community name must match the community name as configured in the
Insight RS Console.
3. In the trap destinations field, add the Hosting Device to the list:
a. To open the SNMP Service Configuration window, click Add.
b. Type the host name or IP address of the Hosting Device.
c. Click Add.
4. Click the Security tab and verify that the community name was added to the list of Accepted
community names.
HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 128 of 267
Chapter 15: Configuring IBM Servers