HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide
Chapter 13: Configuring OpenVMS Servers
Important: Configuration collections for OpenVMSon AlphaServer are not available except
when the OpenVMS server is part of a SAN collection.
Important: HP only provides limited remote support for customers using HP Alpha servers. As
with standard support, HP Insight Remote Support version 7.x will attempt to discover these
products as remotely monitored HP products and send information about failure events to HP.
However, if there are issues with the operation of the remote monitoring features of HP Insight
Remote Support version 7.x for these specific products, including the remote discovery or the
reporting of failure events to HP, then HP will resolve such issues in a commercially reasonable
manner but without guarantee of an immediate response or a resolution. If a failure event is
successfully received at HP, it is managed according to the support level agreement.
Fulfill Configuration Requirements
To configure your OpenVMS servers to be monitored by Insight RS, complete the following steps:
Task Complete?
Make sure Insight RS supports your Integrity OpenVMS server by checking the HP
Insight Remote Support Release Notes.
Install and configure ELMC for OpenVMS on the OpenVMS server.
Add ELMC to the Insight RS Console.
Discover the OpenVMS server in the Insight RS Console.
(Optional) Configure Dynamic Processor Resilience (for Integrity servers only).
Table 13.1 OpenVMS Server Configuration Steps
Install and Configure Communication Software on
Servers
To configure your monitored devices, complete the following sections:
Fulfill ELMC System Requirements
OpenVMS monitored devices must meet the following requirements before ELMC is installed. In clusters,
minimum requirements apply to each node in the cluster.
Page 112 of 267HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide