HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide

d. Click Add.
4. Click Start Discovery.
Note: If discovery is configured to discover standby OAs, it will populate the Devices screen
with minimal information on these devices because although their network interfaces can be
active and be reachable, they are not monitoring port 443 used for communication and therefore
cannot provide Insight RS with information about themselves. Likewise because they are
standby devices Insight RS will not be able to establish event monitoring subscriptions directly
with them. If an OA failover should occur, the OA will pass the subscription to the new Monarch
and Insight RS will continue to monitor the OA for event indications using that active
subscription.
Verify Superdome 2 Discovery
After discovery completes, select Devices from the main menu. Verify that all the Superdome 2 OAs and
HP-UX partitions previously configured for discovery were discovered and that the Status for those
devices shows the success icon ( ).
Verify HP-UX Partitions
For HP-UX devices, verify the device information as detailed in the HP-UX server section. See
"Configuring Integrity HP-UX Servers" on page 89.
Verify the Superdome 2 OA
To verify the device information for Superdome 2 OA devices, complete the following steps:
1. In the main menu, select Devices. Locate the Superdome 2 OA, and click its Device Name.
2. On the Device tab, expand the Status section and verify the Registration Status shows Registered,
and the Enabled has the Yes option selected.
3. Expand the Hardware section and verify the Device Name, Category, Product, Vendor, IP Address,
Acquired Serial Number and Acquired Product Number are populated correctly for the device.
4. Expand the Warranty & Contract section and verify the values listed are correct.
Note: The OS Name and OS Version fields will be blank if viewed from the Operating
System section.
5. Expand the Delivery section and verify the information is correct.
6. Click Save Changes to complete the discovery process for this device.
Note: Insight RS only monitors the Monarch (Active) OA. Insight RS subscribes to the OA that
is active at the time of Insight RS discovery and uses the subscription to listen for events. If an
OA failover occurs, Insight RS continues to monitor the active subscription once it is passed by
HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 109 of 267
Chapter 12: Configuring Integrity Superdome 2 Servers