HP Insight Remote Support 7.0.9 Monitored Devices Configuration Guide
Disable Monitoring of a BladeSystem c-Class Enclosure 147
Chapter 18: Configuring P6000 and Enterprise Virtual Arrays 148
Configuring P6000 and Enterprise Virtual Arrays Using Server Based Management 148
Fulfill Configuration Requirements 148
Install and Configure Communication Software on Arrays 149
Install P6000 Command View 149
Fulfilling P6000 Command View System and Access Requirements 150
Installing HPSIM and P6000 Command View on the Same Server 150
Understanding HP SIM Port Setting Conflicts 150
Installing HP SIM For the First Time 151
Correcting an Existing HP SIM Installation 152
Restore Defaults to the wbemportlist.xml File 153
Installing and Configuring P6000 Command View After HP SIM 154
Documentation for P6000 Command View 156
Installing the ELMC Software Package on the P6000 Command View Server 156
Add Protocol Credentials and Start Discovery 157
Creating P6000 Command View Named Credentials 157
Create the ELMC Protocol in the Insight RS Console 157
Discovering the EVAs 157
Verify Warranty and Contract Information 158
Verify Communication Between Monitored Device and Insight RS 158
Sending a Test Event 158
Maintenance and Troubleshooting 159
Enable User-Initiated Service Mode in P6000 Command View 159
Perform a Remote Service Test in P6000 Command View 160
Configuring P6000 and Enterprise Virtual Arrays Using Array Based Management 160
Fulfill Configuration Requirements 161
Add Protocol Credentials and Start Discovery 161
Creating P6000 Command View Named Credentials 161
Create the ELMC Protocol in the Insight RS Console 161
Discover the ABM 162
Chapter 19: Configuring StoreVirtual P4000 Storage Systems 163
HP Insight Remote Support 7.0.9:Monitored Devices Configuration Guide Page 10 of 267
Contents