HP Insight Remote Support 7.0.9 Installation and Configuration Guide

Note: You can clear this check box at any time to disable automatic operator-level user
authentication.
4. Click Save Settings.
Automatic operator-level user authentication is enabled or disabled.
Add Device Groups
You can group the devices in your environment into logical categories to make administration of settings
easier.
Insight RS contains default device groups created when devices are discovered. Devices belonging to
these groups are automatically assigned to these device groups. Create additional device groups to further
group your devices based on your individual needs.
To create a custom device group, complete the following steps:
1. In the main menu, select Device Groups.
2. In the List of Device Groups pane, click Add New Group.
3. In the Create New Device Group pane, type a name for the group in the Device Group Name field.
4. In the Custom Delivery ID field, type the optional alphanumeric value if one has been supplied to you
by your HPrepresentative. This field allows you to assign a Custom Delivery IDto a group of devices
rather than assigning the IDto devices individually.
5. Click Save Group Name. The system creates and displays the new device group in the List of
Device Groups pane. The assigned devices table appears where you can assign devices to the new
device group.
6. Assign devices in the assigned devices pane. The default view shows devices not assigned to the
device group. To show additional devices, click the Not Assigned to this Device Group or All
Devices options. To show devices in a specific device group, select a device group from the Filter by
device group drop-down list. To search for a specific device, type the device name into the Search
box. The table displays the devices based on your filter and search criteria.
n To add a device, select the check box next to the device in the devices table.
n To remove a device, clear the check box next to the device in the devices table.
7. Click Save Devices.
The system creates and displays the device group in the List of Device Groups pane.
HP Insight Remote Support 7.0.9:Installation and Configuration Guide Page 63 of 81
Chapter 4: Completing Post-Installation Configuration Tasks