HP Insight Remote Support 7.0.9 Installation and Configuration Guide

Chapter 3: Completing the Setup Wizards
This chapter guides you through the Insight RS setup process.
At this point, steps 1 and 2 below are complete. Perform step 3 to complete the setup wizards.
When you first open the Insight RS Console, you must complete the Setup Wizards. There are two Setup
Wizards: the Monitored Device Setup Wizard checks the readiness of the devices you want to monitor,
and the Hosting Device Setup Wizard allows you to enter default settings about your environment. HP
recommends you complete the Monitored Device Setup Wizard first and let it run in the background while
you complete the Hosting Device Setup Wizard.
Access the Insight RS Console through a web browser at: https://<hosting_device_ip_or_
fqdn>:7906. Log on to the Insight RS Console using an Administrator account. You can log on to the
Insight RS Console using any system account, but if the account is not an Administrator account you will
not be able to access the Administrator Settings in the Insight RS Console.
Important: The Setup Wizards are not available in the main menu after you complete them. You
can update the settings elsewhere in the Insight RS Console if necessary. If you need to access
the wizards again, use the following URL: https://<hosting_device_ip_or_
fqdn>:7906/remotesupport/command/viewWizards/.
On the HP Insight Remote Support Setup Wizard screen, you can:
l Complete the Monitored Device Setup Wizard to discover the devices you want to monitor. For more
information, see "Complete the Monitored Device Setup Wizard" below.
l Complete the Hosting Device Setup Wizard to configure the Hosting Device. For more information,
see "Complete the Hosting Device Setup Wizard" on page 43.
Complete the Monitored Device Setup Wizard
The Monitored Device Setup Wizard checks whether Insight RS can communicate with devices in your
environment based on the configured credentials and verifies the devices are ready to be monitored by HP
Insight Remote Support. The Monitored Device Setup Wizard can be left unattended for large
environments. The results can be viewed in the final screen of the wizard or on the Discovery screen in the
Insight RS Console.
The left pane displays each step in the wizard and highlights the current step in green. Complete the
information in each step and click Next to continue. Return to any step in the wizard by clicking Previous
until you reach the desired step.
Page 35 of 81HP Insight Remote Support 7.0.9:Installation and Configuration Guide