7.0.8 Insight Remote Support Release Notes

HP Insight Remote Support 7.0.8 Release Notes
34
Table 14. Supported HP StoreOnce (D2D) Backup Systems (continued)
Product name
Note
Gen 2 single-node
products (continued)
HP D2D2502i Backup System/S-Buy
HP D2D2504i Backup System/S-Buy
HP Capacity Upgrade (1TB) (D2D4112/D2D4312)
HP D2D4106 Capacity Upgrade (12 x 500GB)
HP D2D4324 18TB D2D Backup System
HP D2D4324 18TB D2D Upgrade Kit
HP D2D4324 18TB D2D Replication License
HP D2D4324 18TB D2D e-delivery Replication
License
These backup systems require firmware
version 2.1.03 or above.
Gen 3 single-node
products
HP B6200 Backup System
HP StoreOnce 2620 iSCSI Backup System
HP StoreOnce 4210 iSCSI Backup System
HP StoreOnce 4210 FC Backup System
HP StoreOnce 4220 Backup System
HP StoreOnce 4420 Backup System
HP StoreOnce 4430 Backup System
HP P9000/XP Disk Arrays
HP P9000/XP Disk Arrays are currently not supported with the HP Insight Remote Support 7.0.8 software, but can be
monitored with the HP Insight Remote Support Advanced software.
HP 3PAR StoreServ Storage
HP 3PAR StoreServ storage is not supported with the HP Insight Remote Support 7.0.8 software, but can be monitored with
its own monitoring solution.
HP Secure Key Manager
HP Secure Key Manager is currently not supported with the HP Insight Remote Support 7.0.8 software, but can be
monitored with the HP Insight Remote Support Advanced software.
HP Enterprise Secure Key Manager
HP Enterprise Secure Key Manager is currently not supported with the HP Insight Remote Support 7.0.8 software, but can be
monitored with the HP Insight Remote Support Advanced software.
HP Networking Switches
HP Insight Remote Support 7.0.8 provides product support for selected HP Networking Switches. This includes HP Provision-
based (formerly HP E-Series/ProCurve) and HP ComWare-based (formerly A-Series or H3C/3COM) networking switches.
HP Provision-based Switches (formerly E-Series/ProCurve)
HP Provision-based switches require SNMP for discovery and remote monitoring. These devices ship with SNMP installed
and enabled so that no additional configuration is needed.
Important
Switches configured to use switch stacking capabilities are currently not supported with HP Insight RS. HP Insight RS 7.0.8
only supports standalone mode for these switches.
For configuration collections, please ensure that either TELNET or SSH service is enabled. TELNET is enabled on HP
Provision-based Switches by default. If you prefer to use SSH, you will need to enable it. For instructions, see the HP Insight
Remote Support Monitored Devices Configuration Guide available at www.hp.com/go/insightremotesupport/docs.