7.0.8 Insight Remote Support Monitored Devices Configuration Guide
Chapter 13
Configuring OpenVMS Servers
Important: Configuration collections are not supported on HP AlphaServer products.
Important: HP only provides limited remote support for customers using HP Alpha servers. As
with standard support, HP Insight Remote Support version 7.x will attempt to discover these
products as remotely monitored HP products and send information about failure events to HP.
However, if there are issues with the operation of the remote monitoring features of HP Insight
Remote Support version 7.x for these specific products, including the remote discovery or the
reporting of failure events to HP, then HP will resolve such issues in a commercially reasonable
manner but without guarantee of an immediate response or a resolution. If a failure event is
successfully received at HP, it is managed according to the support level agreement.
Fulfill Configuration Requirements
Complete the following steps to configure your OpenVMS servers to be monitored by Insight RS.
Task Complete?
Make sure Insight RS supports your Integrity OpenVMS server by checking the HP
Insight Remote Support Release Notes.
Install and configure ELMC for OpenVMS on the OpenVMS server.
Add ELMC to the Insight RS Console.
Discover the OpenVMS server in the Insight RS Console.
(Optional) Configure Dynamic Processor Resilience (for Integrity servers only).
Table 13.1 OpenVMS Server Configuration Steps
Fulfill ELMC System Requirements
OpenVMS monitored devices must meet the following requirements before ELMC is installed. In clusters,
minimum requirements apply to each node in the cluster.
Fulfilling Hardware and Software Requirements
l Processor architecture:
n Integrity (Itanium) Server
n HP AlphaServer
l Operating system:
HP Insight Remote Support (7.0.8)Page 99 of 248