7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Monitored Devices Configuration Guide
Chapter 11: Configuring Integrity HP-UX Servers
5. Select 'Q' to exit the EMS Monitoring Request Manager Main Menu.
6. Disable EMS hardware monitors for HP-UX 11i v2 and 11i v3.
a. Check if SFM is used for hardware monitoring:
# /opt/sfm/bin/sfmconfig -w –q
b. If EMS is enabled for monitoring, switch to SFM using the command:
# /opt/sfm/bin/sfmconfig –w –s
7. Run the following command to determine the version of the optional, but recommended, SMH
component is at least version A.2.2.6.2:
# swlist SysMgmtWeb SysMgmtHomepage
The output should look similar to the following:
HP Insight Remote Support (7.0.8)Page 86 of 248