7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Chapter 11
Configuring Integrity HP-UX Servers
Before attempting to configure Insight Remote Support for your HP-UX monitored device, read the
following information.
Note: Insight Remote Support version 7.0.8 only supports HP-UX on Integrity servers.
Fulfill Configuration Requirements
Complete the following steps to configure your Integrity HP-UX servers to be monitored by Insight RS.
Task Completed?
Make sure Insight RS supports your Integrity HP-UX server by checking the HP Insight
Remote Support Release Notes.
Install System Fault Management prerequisites on the Integrity HP-UX server:
l OS patches
l OpenSSL Secure Network Communications Protocol
l Online Diagnostics
l WBEM Services Core Product
l System Management Web
Install and configure System Fault Management on the Integrity HP-UX server.
Configure WBEM users on the HP-UX server.
Set firewall to allow communication on specific ports.
Add the WBEM protocol to the Insight RS Console.
Discover the HP-UX server in the Insight RS Console.
Send a test event to verify connectivity to the Hosting Device.
Table 11.1 Integrity HP-UX Server Configuration Steps
Install System Fault Management
System Fault Management (SFM) is an Insight Remote Support communications requirement on all
supported versions of HP-UX. SFM has many patch prerequisites, and those are detailed in the section
"Meeting HP-UX Operating System, Software, and Patch Requirements". If your system(s) already meet
the minimum requirements identified in that section, then you do not need to remove or reinstall those
components.
HP Insight Remote Support (7.0.8)Page 78 of 248