7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Chapter 9
Configuring Integrity Windows 2008 Servers
This information applies only to Windows 2008 Integrity monitored devices.
Fulfill Configuration Requirements
Complete the following steps to configure your Integrity Windows 2008 servers to be monitored by Insight
RS.
Task Complete?
Make sure Insight RS supports your Integrity Windows 2008 server by checking the HP
Insight Remote Support Release Notes.
Install WBEM on the Integrity Windows 2008 server.
Add the WBEM protocol to the Insight RS Console.
Discover the Windows 2008 Integrity server in the Insight RS Console.
Send a test event to verify connectivity between your Windows 2008 Integrity server
and Insight RS.
Table 9.1 Integrity Windows 2008 Server Configuration Steps
Install WBEM Providers on the Monitored Device
For your Windows 2008 Integrity monitored device to be discovered by the Insight RS Console and to
support configuration collections, you must have HP Integrity WBEM Providers for Windows Server 2008
installed and fully configured on your monitored devices as directed in the HP Smart Setup product
documentation for the appropriate package. Windows 2008 Integrity monitored devices also use WBEM
for event submission/remote monitoring.
Windows Integrity servers shipped by HP manufacturing have the Smart Setup installation files pre-
loaded on the operating system disk. Otherwise the packages can be installed using the Smart Setup CD
or reinstallation media. You can download the Smart Setup CD or Integrity Support Pack at:
l Windows Server 2008:
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareIndex.jsp?lang=en&cc=us&prodName
Id=3346453&prodTypeId=15351&prodSeriesId=3346452&swLang=13&taskId=135&swEnvOID=4023
l Windows Server 2008 R2:
http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareIndex.jsp?lang=en&cc=us&prodName
Id=3346453&prodTypeId=15351&prodSeriesId=3346452&swLang=13&taskId=135&swEnvOID=4068
For WBEM Providers to communicate to the Hosting Device, you must provide the WBEM credentials
within the Insight RS Console when you are completing the Insight Remote Support configuration.
HP Insight Remote Support (7.0.8)Page 73 of 248