7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Monitored Devices Configuration Guide
Chapter 2: Configuring ProLiant Gen8 Servers
5. Check the Insight RS Console to verify that the test event arrived:
a. Log on to the Insight RS Console.
b. In the Main Menu, click Devices.
c. Find the Gen8 ProLiant server and click the device name.
d. Click the Service Events tab. All service events submitted against the system display in the
Service Events screen (even if you clear the Service Event Log).
Insight RS converts the iLO service event Time Generated value to the time zone of the browser
used to access the Insight RS Console.
Note: Test events are automatically closed by HP since no further actions are required.
Initiate a Data Collection
You can test your collections from the iLO 4 web interface or the Insight RS Console. Collections are
automatically generated during Discovery. You do not need to manually run collections unless you want to
test your configuration.
Note: Insight Remote Support will run a data collection when the ProLiant server is discovered.
If you manually generate a data collection using one of the methods described below, you will
have two data collections shown for the device in the Insight RS Console.
Initiating a Data Collection in the iLO 4 Web Interface
To initiate a data collection in the iLO 4 web interface, do the following:
HP Insight Remote Support (7.0.8)Page 32 of 248