7.0.8 Insight Remote Support Monitored Devices Configuration Guide

Monitored Devices Configuration Guide
Chapter 2: Configuring ProLiant Gen8 Servers
3. Select iLO Remote Insight Board Command Language Protocol (RIBCL) from the Select and
Configure Protocol drop-down list and click New.
4. Fill in the required fields. Use the Username and Password of the iLO 4 web interface on the ProLiant
Gen8 server.
5. Click Add.
Discover the ProLiant Gen8 Server
Enable the ProLiant Gen8 server for Insight Remote Support in one of two ways:
l Discover the ProLiant Gen8 server from the Insight RS Console.
See "Discovering the ProLiant Gen8 Server from the Insight RS Console" below.
l Register Remote Support from the ProLiant Gen8 server iLO 4 web interface.
See "Enabling Insight Remote Support for a ProLiant Gen8 Server" below.
Note: You can also register for remote support through the Intelligent Provisioning interface.
For more information, see HP Insight Remote Support and Insight Online Setup Guide for
ProLiant Gen8 Servers and c-Class BladeSystem Enclosures, available at:
http://www.hp.com/go/insightremotesupport/docs.
Discovering the ProLiant Gen8 Server from the Insight RS
Console
To discover the ProLiant Gen8 server from the Insight RS Console, do the following:
1. In a web browser, log on to the Insight RS Console.
2. In the Main Menu, select Discovery and click the Sources tab.
3. Expand the IP Addresses section and set up the IP range for the devices you want to discover. For a
Gen8 server, use the IP address of the iLO.
4. Click Start Discovery.
Note: After discovery, the operating system for the Gen8 server will not appear in the Insight RS
Console. This is expected behavior.
Enabling Insight Remote Support for a ProLiant Gen8
Server
With the HP iLO Management Engine, no additional protocols need to be installed on the ProLiant Gen8
server. You only need to register the ProLiant Gen8 server with your Hosting Device to enable Insight
Remote Support. You can register Insight Remote Support for a ProLiant Gen8 server in the iLO 4 web
interface.
HP Insight Remote Support (7.0.8)Page 29 of 248